Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10 Manuel d'utilisateur télécharger pdf (Page 134)

Distributed Clocks SYNC/LATCH Signals

III-122 Slave Controller – IP Core for Altera FPGAs

11 Distributed Clocks SYNC/LATCH Signals

For details about the Distributed Clocks refer to Section I.

11.1 Signals

The Distributed Clocks unit of the IP Core has the following external signals (depending on the ESC

configuration):

EtherCAT

device

LATCH_IN0

SYNC_OUT1

SYNC_OUT0

LATCH_IN1

Figure 60: Distributed Clocks signals

Table 61: Distributed Clocks signals

Signal

Direction

Description

SYNC_OUT0/1

OUT

SyncSignals (alias SYNC[1:0])

LATCH_IN0/1

LatchSignals (alias LATCH[1:0])

NOTE: SYNC_OUT0/1 are active high/push-pull outputs.

11.2 Timing specifications

Table 62: DC SYNC/LATCH timing characteristics IP Core

Parameter

Min

Max

Comment

DC_LATCH

12 ns + x

Time between Latch0/1 events

DC_SYNC_Jitter

11 ns + x

SYNC0/1 output jitter

DC_SYNC_IRQ_pulse_width

40 ns

SYNC0/1 pulse width if the SYNC0/1

signal is used as AL event request (PDI

interrupt) signal (masked by register

0x0220 ff.), and if acknowledge mode is

not used.

LATCH0/1

DC_LATCH

Figure 61: LatchSignal timing

SYNC0/1

DC_SYNC_Jitter

Output event time

DC_SYNC_Jitter

Figure 62: SyncSignal timing

EtherCAT IP Core: time depends on synthesis results

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 140 141

Commentaires sur ces manuels

Pas de commentaire

Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10 Manuel d'utilisateur Page 134

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10