Beckhoff CP29xx Manuel d'utilisateur télécharger pdf (Page 17)

Mounting

4.1.5 Fitting the power supply cable

Fit the cables for the power supply of the Control Panel, using the included material for assembling the

connectors:

Material for assembling

the connector

Plug connector 5-pole

Stain relief housing with lacing cord

Conductive cross-section

Note

The connector is specified for 16 A and can lift conductive cross-sections until 1.5 mm

So the connector is fitted to the cable

1. Strip insulation from the cable ends (Length of stripped conductor is 8 - 9 mm).

2. Screw together the cable ends in the 5-pole plug connector in accordance with wiring diagram.

Applying the strain relief

Thread the lacing cord into that lower part of the stain relief

housing.

Putting in the plug connector

Put the plug connector into that lower part of the stain relief

housing.

Tighten the lacing cord and pinch off the plastic strap.

Fixing the upper part of the stain relief housing

Fix the upper part of the stain relief housing by snapping it onto

the lower part.

CP29xx 15

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Pas de commentaire

Beckhoff CP29xx Manuel d'utilisateur Page 17