Beckhoff FC5101 Manuel d'utilisateur télécharger pdf (Page 13)

Eiserstraße 5 / D-33415 Verl / Telefon 05246/963-0 / Telefax 05246/963-149

3. Fitting and wiring

Installation

Fieldbus PCI cards may only be fitted by qualified personnel in accordance and the following

points must be observed.

· In order to protect the card from electrostatic discharge the user must be discharged before handling

the card or the PC.

· Before opening the PC housing it must be switched off, and the mains plug must be removed.

In may be necessary before fitting to set the jumper in order to activate the internal CAN bus terminating resis-

tors, or to set the switch (as from hardware version 3). The jumper being set or the switch being on means that

the terminating resistor is connected.

The card can be fitted into any free PCI slot. Ensure that the PCI bus connector is making good contact, and

that the module is seated firmly. Fasten the module to the PC slot housing with the fixing screw.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 94 95

Pas de commentaire

Beckhoff FC5101 Manuel d'utilisateur Page 13